[demaniacballer]

ok so i am going through the modes on my 05 ego with virtue and i had it on full auto. i held the trigger down for a few seconds and i let go.the trigger stuck their for about 1 second and it keeps sticking any one have this happen to them any one got a idea why?

[RamapoLax]

Take the trigger out and frame off and clean the inside.

[superbuddha14]

RamapoLax is right, just take it apart and give it a good cleaning. all the old paint and gunk probably seeped into the spaces to make it sticky

[ice_beachball]

Only time i've seen it happen is when it's dirty. Make sure your pin isn't rusted as well.

[Bill]

When you take the pin out you can polish it with some emery cloth or scotchbrite. Use a bit of oil on it when you re-install it.

[darkzeith]

Clean it, I believe its paintd

[demaniacballer]

well im newer to egos and dk how to take out the trigger could i just take the frame partly off and swab it out?

[Tom on Myspace]

Well don't half *** it.

Take the grips off, remove wires from board. Take the 2 frame screws off, grab your frame and look down at the trigger, there should be a small set screw, unloosen that and the pin should slide right out... Clean it, oil it just like Bill said.

[demaniacballer]

thanks its better but their is a hole in my solonoid.idk why.the screws are short so short they dont reach the noid its on the left side is it supposed to be here?

[jamesbobob]

Hybrid grips or stock grips? The screws are probably too long and punctured the noid, I've seen it 1,000 times.

[Tom on Myspace]

If you bought the gun used, than must have been something the previous owner has done.

I had hybrid grips on my 06 no problems.... But you MUST have the shortened screws so you can be alright.