If you want to reduce the amount of roll back in your nt there is a solution.
I thought of putting an oring on the flow insert, and after confirming that it has been done with MorpheusX. For my personal nt I am currently using a metric 6x1mm oring. I have yet to try it on the field, which will happen this weekend. Then I'll post results
I'm hoping this will reduce breaks even more by keeping the ball stack more vertical and reduce potential ball clipping.
Hope this helps some people out.... If you try it out post up what you used to shim your flow tip and your results
Saw you posted this mod in another thread. Worked great... No more last ball breaks! Bolt sticks out just enough, but not too much to obstruct the breech. Thank you for this tip. Shot ultra last weekend with no issues and no breaks.
Glad you guys are having good results. I have a few more things I am going to experiment with in the next little bit I just need to find the time to order the parts and get the work done. Hopefully make it more gentle on paint as well.