OK, I finally got a break from school and work and had time to look into this a little more. I have a seventh element board and it says that the dwell should be 10 if am reading the manual correctly. I was going to program it to make sure it was correct, but I have never worked with these boards (or any boards really. Just getting into electros ) and cannot locate the dip switch to make sure that dip switch 2 is turned on. Anyone know where it is? Also are far as bolt and ram setup go it looks like I have the stock ram and bolt when I aired it up just the tip if the bolt was visible when I looked down the feedneck. Here is a pic of the bolt and ram.