[ryan_wallace92]

Originally Posted by asdffdsaasdf

well then try the rotating 180 degrees thing

if that works then your rammer is at fault

if it dosent then its your bolt pin

talk to infinity and see what they say


also take your rammer out and mae sure its fitting in there right

im pretty sure that its the fact that the soft face doesnt have the screw, my stock bolt works perfectly fine

[asdffdsaasdf]

talk to infinity and tell them the spring on the pin isnt strong enough to hold it down

[asdffdsaasdf]

updated again

do you want this stickied? if so contact drefish

[asdffdsaasdf]

should i stop updating this ... does anyone even read it

haha

[berserker19]

Originally Posted by asdffdsaasdf

does anyone even read it

I do... That's why you never see me posting here with "legend help" questions It should probably be stickied

[niagara_destruction]

this is adding to my soft face bolt issue (i am ryan_wallace92)

i emailed infinity about my problem, and i got an email back saying to file down the part of the bolt that goes into the ram because of burrs

it worked, so you can update that

[asdffdsaasdf]

thats why it poped out?

when you let me know if thats it and ill add it

[asdffdsaasdf]

! updated !


and im off to lunch!

[whiteboimagic]

sticky

[asdffdsaasdf]

finally got around to adding the soft face bolt chopping issue (smaller bumper o ring)

[Formula51]

yes this needs to be stickied.

asdffdsaasdf for Mod '08!

[whiteboimagic]

is that the o ring that, the soft face bolt owners gotta have?

[niteowl79er]

Originally Posted by whiteboimagic

is that the o ring that, the soft face bolt owners gotta have?

YES
but a thinner version.

[asdffdsaasdf]

updated

[asdffdsaasdf]

added something new!

burton iv never heard of your problem ... but now its in here for others to see

[brando123]

sticky this! it helps MUCHO

[insane24]

i turn on my legend....and on one trigger pull it shuts off....i have the legend tadao board w/ the 6 color...pm me plz if anyone knows the problem

[HeavyD4thekids]

disconnect your board, from teh harness, then reconnect. use a fresh batt, put in programming mode, and make it go into default settings. then try again

[insane24]

ok i d.c'd the board...plugged back in...so i thought was all good...then i put air into it....pulled trigger w/ eyes on it works. turn eyes off and pull trigger and it dies.. no air flow coming from anywhere. any other suggetions?

[county_storm05]

sticky

and i might have something to add if i can confirm what the actual cause of the problem is

[asdffdsaasdf]

I TOTALLY forgot about this thread. Thanks for bringing it back to my attention.

Edit: A few updates!