our tech cant get the myth reg off my 45/3000 steelie... any advice?
Please check out this very informative video from Hustle Paintball.
Sorry everyone for the late responses, I was a bit backed up, but now I am good to go. In the future for immediate service please call at 260-478-2500 x251 or e-mail us at service@tiberiusarms.com
__________________ Boneyard Paintball in Plymouth, WI Stinger Paintball Designs for your custom grips
"Reminds me of the kids that bolt on exhausts, wings and vinyl cutouts onto their rice mobiles and then hate on a ground up resto rodded 69 Camaro" -OPBN
ok, well mine right now is putting out around 1100. pretty happy about it
__________________ Boneyard Paintball in Plymouth, WI Stinger Paintball Designs for your custom grips
"Reminds me of the kids that bolt on exhausts, wings and vinyl cutouts onto their rice mobiles and then hate on a ground up resto rodded 69 Camaro" -OPBN
Have a Myth G2 Reg that is doing something weird as of today. When I put my cover on my fill nipple it literally shot off, it is a CP nipple cover so it is sealed with orings so I am assuming I have a leak in my fill nipple? Had it happen 3 times today which led me to obviously not use a cover. Little Help? Replace the fill nipple?
Have a Myth G2 Reg that is doing something weird as of today. When I put my cover on my fill nipple it literally shot off, it is a CP nipple cover so it is sealed with orings so I am assuming I have a leak in my fill nipple? Had it happen 3 times today which led me to obviously not use a cover. Little Help? Replace the fill nipple?
Eric
That is odd.
Submerge the tank in a clear cup of water and let me know if bubbles are coming out of it.
If it is, empty out the air system and remove the fill nipple.
Inspect the o-ring in the strut inside the fill nipple; make sure there is no damage on the o-ring. If there is, then try to replace the o-ring ( you need a 006-90 polyurethane o-ring). It is difficult to replace the o-ring, but if anything just get a new fill nipple. To instal it back, make sure to use teflon tape or loctite on the threads to seal it back up; leave around 1 thread and half sticking out to allow the strut to shut on/off.
I just recently purchased a brand new tank of yours off ANS. Now I have not had it longer than a month and have only played with it twice. Both times the same o-ring on the piston cracked causing it to leak. I have switched the o-ring more than I already should have for a brand new tank. Someone on my local field said its a common problem with the regulators where it takes in to much air at once and could be freezing my o-rings causing them to crack. Does this make any since to you? If so how can I fix it?
I just recently purchased a brand new tank of yours off ANS. Now I have not had it longer than a month and have only played with it twice. Both times the same o-ring on the piston cracked causing it to leak. I have switched the o-ring more than I already should have for a brand new tank. Someone on my local field said its a common problem with the regulators where it takes in too much air at once and could be freezing my o-rings causing them to crack. Does this make any sense to you? If so how can I fix it?
Did you add chemplex 710, dow 33, or any other non oil based grease to the o-rings? Just add a thin layer over it and you should be okay. If you did, then this is very odd.
, but please contact your local Paintball shop to order the Low Pressure kit for you. 
