after i got home from playing all day i decided to complete strip the marker down and clean it, after putting everything back together it leaks every time i gas up the marker through the bottom adjustment screw.
after comparing my reg to the one on the manuals diagram it seems i have a washer were the spring sits but its not shown in the diagram.
i removed the washer/shim and the leak went away i think, there is a faint faint sound but i think its from the macroline fitting so i removed it and put some blue locktight. Going to let it cure then see if it still leaks
i dont have any spare orings for this gun, guess i have to get a small parts kit
No prob.
That o-ring is a 3.69mm inside diameter (ID) X 1.78mm cross section (CS) a.k.a. a standard -007. You may be able to find that size at an ACE hardware store. Just look for the nominal size of 5/32" ID X 9/32" outside diameter (OD) X 1/16" cross section.
__________________ Graphite Dangerous Power REV-I
– TechT bolt engine, REV-I & Disruptive barrel kits, Prophecy V2 w/ Empire feedgate, Crossfire SS 68/4500 Maroon and Polished Aluminum Dangerous Power Threshold
– 7th Element board, TechT bolt engine, magnet trigger kit, REV-I PMD, Sly Dual Carbon barrel kit, Prophecy V2, Crossfire SS 68/4500 Black and Silver Dangerous Power F8
– APE Rampage board, VS bolt, magnet trigger kit, F8 gauge, REDZ barrel kit, Halo B w/ Exalt feedgate, PMI 68/4500 Polished Aluminum and Red Dangerous Power F8
– Virtue board, VS bolt, magnet trigger kit, Halo B w/ Exalt feedgate, PMI 68/4500
That o-ring is a 3.69mm inside diameter (ID) X 1.78mm cross section (CS) a.k.a. a standard -007. You may be able to find that size at an ACE hardware store. Just look for the nominal size of 5/32" ID X 9/32" outside diameter (OD) X 1/16" cross section.
well i got some good news, i can get any orings i want from work at a very low discount since we buy in bulk all the time.
any chance you have a list of all the orings this gun uses?
Yup. You can use my o-ring chart as a cross reference to find out the standard size equivalents - the standard sizes are in the ( ) on the chart. Example would be that 3.69mm ID X 1.78mm CS velocity adjustment screw o-ring. That is shown on the chart in mm but also has the (-007) - the standard equivalent.
__________________ Graphite Dangerous Power REV-I
– TechT bolt engine, REV-I & Disruptive barrel kits, Prophecy V2 w/ Empire feedgate, Crossfire SS 68/4500 Maroon and Polished Aluminum Dangerous Power Threshold
– 7th Element board, TechT bolt engine, magnet trigger kit, REV-I PMD, Sly Dual Carbon barrel kit, Prophecy V2, Crossfire SS 68/4500 Black and Silver Dangerous Power F8
– APE Rampage board, VS bolt, magnet trigger kit, F8 gauge, REDZ barrel kit, Halo B w/ Exalt feedgate, PMI 68/4500 Polished Aluminum and Red Dangerous Power F8
– Virtue board, VS bolt, magnet trigger kit, Halo B w/ Exalt feedgate, PMI 68/4500
I just did this on my marker last night - I noticed it was leaking from the same spot; all I did was move in the velocity adjustment and the leak stopped - I am not sure if it just needed to seat or if I had it to far out after reassembly.
Your Privacy Choices