[paintballer67]

i need help, my timmy isnt working right;i cant get it to shoot without it leaking from the lcd area, so to get it to shoot i turned up the pressure but then it leaked, i turned down the pressure so it doesnt leak but then it wont shoot...its really annoying me so PLEASE suggest what i could do thanks alot (ps; all adjustments were made with the lp reg)

[mitch_69]

Do u have gauges on your regs? If not put a gauge on your LP reg, set it at 85PSI and leave it there, adjust the velocity with you HP reg. It is leaking because you are tourning the pressure up too high, the solenoid is supposed to VENT at about 120PSI. Hope this helps.

[paintballer67]

i can get it to stop leaking, but then theres like no pressure going into the gun...do i just turn the lp in to make it stop leaking and then turn out the hp to make it shoot????

[mitch_69]

Put a gauge on your LP reg and set it to 85PSI, then use the HP reg to get the right velocity.

[paintballer67]

ok, thanks alot for your help, i appreciate it!