[Intern1]

So I replaced the or-ing on my valve and I put my gun back together, but now i can't get the gun to cock. Its like its not cathing on the sear or whatever its called. I tried screwing it in a ton and nothing. Then I tried backing it out and still nothing. Does anyone have any advice before I take it to the shop?

[PeaTear_Griffin]

Is your lpr turned up high enough to cock the gun? Are you sure your allen key is getting into the slot on the lug?

Is your cocking rod screwed in all the way or is it out of adjustment?

[Dk-79]

Pull the trigger frame off the bottom of the body and look up at the little groove where the hammer lug sits.

It should sit relatively close to the bottom of the body. and you can fine tune it once it's catching the sear.

[Hogzilla88]

Remove the bolt, and cock the gun. Then stick your 1/8 allen wrench through the hole in the top of the body, and stick it into the head of the lug. You may have to pull the cocking rod a little to get it lined up right. Then lower it until it will reliably catch on the sear.

[Intern1]

I haven't hooked it up to any air yet so I don't know about the lpr being too high. I guess I just have to mess with it some more.

[Intern1]

Thanks a lot everyone! Tightening the lug even more fixed the problem. i guess I loosened it more than I thought when I took it apart.

[Digital-Paintball-3]

You should visit a reseller, or just go with it on the field were other players are. There always people who know the tiny insides

[Intern1]

My field is only open on weekends and the cloest shop is a half hour away, so that a 1 hour round trip and they don't tech cockers at my shop. Not to mention no one is smarter than the nation!