Shocker SFT virtued yes problem

WeroMontiel · #1 11-17-2009, 07:11 PM

Im novice about all Shocker stuff. I resurrected and old SFT from the deaths and i bought a virtue board for it, but my eyes are not working. i need help!

pleace advice!

NYCBaller95 · #2 11-17-2009, 07:59 PM

Make sure you have your board set to reflective and ont break beam.

shockerboy001 · #3 11-17-2009, 08:28 PM

Quote:

Originally Posted by NYCBaller95

Make sure you have your board set to reflective and ont break beam.

+1 read the manual if a problem keeps up i would replace the eyes.

Uziel Gal · #4 11-18-2009, 02:11 AM

Is your marker firing without a ball in the breech, but not firing when there is? If so, your eye logic is reversed, and you need to change the eye logic.

If that isn't the issue, try a fresh battery; make sure the eye is clean; check the eye ribbon for kinks/breaks/damage; make sure the eye ribbon is plugged in to the upper board the right way up; check the sides of the upper board for screw damage; make sure that there are no broken/loose wires in the harness; check the harness sockets for bent pins.

WeroMontiel · #5 11-19-2009, 01:38 PM

Thanks for your response buddies!!!!

I already change the eye ribbon for a new one but still is not working.

I already checked the user manual of the virtue/nerv board but it doesnt have it the eyes option(yellow led)!.

Any clue?. Did i need to send my virtue board to flash/udgrade?!?!?!!

WeroMontiel · #6 11-19-2009, 01:48 PM

Uziel Gal:

Thanks buddy, i already checked that and the connector of the eye ribbon to the upper board was damage, so i bought a new one, but still not wirking!.

My upperboard works fine, all cable are connectec, noid work Ok,

----------------------

NYCBaller95:

My virtue board doesnt have the eye option(yellow led), i checked the manual!...

shockerboy001:

eye ribbon changed! but still the same bro!

NYCBaller95 · #7 11-19-2009, 04:23 PM

See if any of this helps you- http://www.zdspb.com/tech/mguide/sho...le_vision.html

Uziel Gal · #8 11-19-2009, 05:47 PM

You obviously have an older board if it doesn't have the yellow register to change the eye mode, but in that case, it isn't an issue (though it wouldn't be a bad idea to get your board updated - the Redefined Virtue code has some nice additional features, over and above the eye mode) - the older Virtue boards were reflective eye only, which is just what you need for a stock SFT.