SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD SOLD
Paypal preferred or USPS Money Order
Post and PM please
Wife
says I need to sell some more gear
so here it is
*VSC Phantom with M-16 grip
*8" Barrel
*11" Barrel
*Trigger shoe
*Velocity adjusting rod(TPC)
*Harness, holds 12 tube/co2, comes with 8 tubes/caps(fits up to 32" waist)
*M-16 Mounting block with screws(needed to mount asa or stock)
*ASA with straight Macro fitting
*Rail
*Regulator with 90* new Macro fitting on bottom of regulator(90* fitting not shown but will be included)
*7-3/4" piece of Macro line, needs to be cut to length
*1 spare new ball retainer(not pictured but is included))
*1 spare new main spring(not pictured but is included)
*1 co2 cartridge so you can verify the marker works when you get it!
Hardsided case can be added for free!
ASA, Rail and Regulator have a "brushed aluminum" look thanks to my Dremel and some fine grit sandpaper. I got tired of looking at the scratched black ano
Regulator isn't needed and may decrease consistency since Phantoms are very consistent as it is(haven't tried it with the reg yet). I've only used the reg without shims so it never messed with the consistency. Reg is there more out of habit(hand position) than anything else. You can always chuck the regulator and put a CP Gas Thru on instead. I just had the regulator lying around so I used that instead
Puncture seal has been replaced! Marker works flawlessly! All individual parts are sealed in a heavy duty(not pos Ziploc) plastic bags.
Price is 250
EDIT: Tried the regulator with shims using the CA setup and it works fine(not much fluctuation in velocity). I'm guessing the rate of fire isn't high enough to impact the velocity as much as it would a semi. So consistency is fine with the regulator with shims but didn't check efficiency(shots per).
Pic with case added. Have vid as well, taken Sep. 01, 2009 to show marker works. Can verify
