Find fields & stores near you!
Find fields and stores
PbNation News
PbNation News
Community Focus
Community Focus

Thread Tools
Old 08-07-2014, 04:35 PM #1
Join Date: Aug 2014
ModanosRobe has achieved Level 1 in PbNation Pursuit
NT11 What insert do I use on my tank? etc.

Just bought an NT11 with a modded blue spacer insert from Billy Wing. With this setup, should I set my tank to 450...550...650? How do you know which to choose?

Which bolt tip do you use? How do you know?

Is it all dependent on the paint you are using?

Also, since Billy Wing apparently has a hand in designing these markers...why do people send the guns off to him aftermarket to have him service and mod them? What exactly does he do when you send it to him and how much does it cost?
ModanosRobe is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Old 08-07-2014, 04:42 PM #2
Read the manual!!
gamer565's Avatar
Join Date: Dec 2005
Location: OK
Annual Supporting Member
gamer565 is playing at Living Legends VI
gamer565 is playing at Living Legends VII
gamer565 posts videos on PbNation
gamer565 is reppin' sidebar 4 life
gamer565 has achieved Level 6 in PbNation Pursuit
gamer565 is one of the top 100 posters on PbNation
gamer565 is Boss
Better off asking in the correct section..
Jolly Green (╯□)╯︵ ┻━┻

gamer565 is online now   Reply With Quote
Old 08-08-2014, 08:52 PM #3
Melon Bands
Low Key AF
Melon Bands's Avatar
Join Date: Jun 2014
Location: STL
450psi. That is pressure the for most modern guns. It will increase your efficiency and reduce the chance of macroline leaks.
Melon Bands is offline   Reply With Quote
Old 08-09-2014, 02:36 PM #4
liquidfiretibby's Avatar
Join Date: Aug 2011
Location: etters, pa
Annual Supporting Member
liquidfiretibby plays in the PSP
liquidfiretibby owns a Planet Eclipse Etek
liquidfiretibby posts videos on PbNation
liquidfiretibby plays in the APPA D4 division
liquidfiretibby has perfected Level 3 in PbNation Pursuit
doesnt matter cuz the hyper 3 reg will bring it down to operating pressure before it hits the noid....

liquidfiretibby is offline   Reply With Quote
Old 08-09-2014, 03:04 PM #5
cmdrsuds's Avatar
Join Date: Apr 2011
Location: Colorado
Tank output is almost irrelevant, but 450 is fine.. it will make the on/off switch for the tank much easier to turn.

The flow insert should be green, since it has the largest whole. Bolt tip should be black. Don't use any spacers in the body, some people also raise their dwell to 8-10 and set the reg 110-120psi

WTB Tampa Bay Damage NT11
cmdrsuds is offline   Reply With Quote

Thread Tools

Posting Rules
Forum Jump