Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 05-24-2014, 09:47 PM #1
Mr.Dirt
 
 
Mr.Dirt's Avatar
 
Join Date: Aug 2005
Location: CFL
Mr.Dirt is reppin' sidebar 4 life
Mr.Dirt has achieved Level 1 in PbNation Pursuit
Bob long 360 issues

Hey, I'm having trouble with my 360 reg spiking. I set it up on a spare asa to get the output pressure and it seems to spike after 250 psi. From 100 to around 250, it goes up 50 psi for just about every quarter turn, but after that it gets very sensitive, increasing about 50 psi for every little turn of the wrench. Anything past 325 and it spike up to 450 and stays steady, regardless if I back it off or not(my gauge was leaking a bit on my asa tester setup so I found that odd it would still stay even after backing off the bottom screw completely.) Another thing is that when it is in the sensitive "spike" range(above 250) it will jump all the way up to 800 psi after one shot, or if I simulate a shot by bleeding the asa that the regulator is screwed into. Anything below 250, and it is fine, I can put it on my gun and it works fine shot after shot(its a pump cocker, so I'm not worried about it blowing a noid or anything.) I took it apart, relubed all the orings, yet the problem still persists. Any ideas?
__________________
Feedback
Sacrifice
Your Role Might Be Thankless, But If You're Willing To Give It Your All, You Might Just Bring Success To Those Who Outlast You.

WTB MQ Valve Urethane dot's
Mr.Dirt is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 05-25-2014, 09:43 AM #2
Tabris17
Will B/S/T Souls
 
Tabris17's Avatar
 
Join Date: Jan 2006
Location: Connecticut
Annual Supporting Member
Tabris17 is a Moderator
Tabris17 is BST Legit
Tabris17 supports our troops
Tabris17 is one of the top 250 posters on PbNation
Tabris17 is Boss
Tabris17 is attending Decay of Nations VII
Which piston version do you have? White delrin or is it metal? If it's delrin, they could be worn out if you notice any scratches/gouging.
Also, change the piston o-rings themselves with fresh ones. Check the manual and double check the shims are in the correct order. A marq or g6r manual should have the correct order. Last thing could be a bad pin valve but I highly doubt that.
__________________
Owner of the Silent Hill Cyborg... the most evil marker in paintball.
KGB MOB

"Only the foolish believe suffering is just wages for being different. Only the savage regard the endurance of pain as the measure of worth. Only the insane equate pain with success."

PBR Feedback +26/-0 PBN Feedback +16/-0 IOG Feedback +10/-0
Tabris17 is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump