hammer lug is either too high and not catching, or too low and not releasing. also make sure the battery is good.
to see if the hammer lug is adjusted properly you can take off a grip panel, cock the marker, and slowly push the plate of the sear solenoid up with your finger. it should release the hammer about halfway through its travel.
lpr should be set just high enough to fully cock the marker, then a little more for reliability. it just moves the bolt back and forth to cock the marker, otherwise it doesnt affect the firing or velocity like it would on a timmy/ego.
edit: also make sure the sear noid isnt full of gunk or the grips arent on too tight. if it needs cleaning make sure to not put any lube or anything on it afterwards.
Last edited by Rebel_816 : 02-18-2014 at 05:57 PM.