no, didn't remove anything- didn't need to. hang on-
That's the board with both the microswitch leads on, but without the battery leads connected
There's the board as it is now- sorry about the bad pic, it was a rushed shot. the Back and red lines are the battery leads, and the orange is a Microswitch line (I was having problems with the other, and it disconnected earlier, I just need to reattach it). I tested the whole thing with the battery leads earlier- they're ok and work.
Outside- the membrane pad. There were two nubs there for the old fire-selector switch, But I filed them down before I attached the membrane. it popped off once after being stickied on, so I epoxied it in place with some non-conductive stuff I had.
the inside of the membrane pad. The pins are all in flush and nothing is cut or nicked in the lines, so I don't know what it is.