[frosticle]

Yesterday I played my first tournament. I had installed a new battery and stripped and cleaned the gun a few days before. I chronoed the gun before the first game and everything was good. When play started the gun was acting as if it wasn't registering the trigger pulls and was firing semi. It would then suddenly start ramping and then stop all the while I was still walking the trigger as I normally would. After the game I tested it and it seemed fine at first and then started again. I checked the eyes and it was registering that there was a ball detected. I even turned the eyes off and it was doing the same thing. Any ideas?

[msweeneygt]

Have you checked what firing mode your in?

[Sdfy]

Make sure you correctly set the firing mode, and also make sure you correctly set that your ramping is set to 12.5 bps.

[aresfiend]

Originally Posted by Sdfy

and also make sure you correctly set that your ramping is set to 12.5 bps.

Depends on his tourney.

You might be in Millennium mode where you have to walk 8bps, which can be confusing if you don't almost strictly play semi.

[frosticle]

I did check to make sure it was in the correct mode and set to 12.5 (played in the cfoa). Just seemed like the tigger wasn't registering the pulls at times. When I switched to my etha had no issues with the ramping kicking in just fps issues which made for a great day.

[frosticle]

I adjusted the lpr and tested it and it seems to be working properly now.