2k2 timmy, 2 quick questions

Djzapz · 03-01-2013, 02:21 PM

Hello, I just have 2 questions, this timmy was kind of a disaster and now it's about to be whole again

.

First, I need the screws for the side plates, where can I get those?
Second, is it normal that the gun leaks at the bolt when the pressure is too low? If not, is there a problem with the ram o-rings perhaps? Let me know. Thanks!

StyngRay2 · 03-01-2013, 03:02 PM

search bst for the screws, go to ace hardware, or call blast. and if you pressures on your regs are incorrect you could leak down the barrel. but if your pressures are within normal range hpr 225-250 and lpr 70-90 'ish....you shouldn't have any barrel leaks.

Djzapz · 03-01-2013, 03:28 PM

Alright will do. Wish I had a gauge for the HPR tho

Cheers

StyngRay2 · 03-01-2013, 03:41 PM

you really dont need one...just sweet spot your regs and you'll be good.

Djzapz · 03-01-2013, 05:11 PM

I'm not familiar with Timmies at all though but I can fine tune DM's very easily. I'm out of air for the next few weeks though so I can't try to tune it, but does it work like DM's?

I would basically open up the HPR a little, get the LPR to cycle with a little head room, and then set the HPR to 290fps or something. That's how I do my DM, just not sure if it's the same here.

gamer565 · 03-01-2013, 05:32 PM

That will work for intimidators too.

Djzapz · 03-01-2013, 05:48 PM

Alright ty