Find fields & stores near you!
Find fields and stores
PbNation News
PbNation News
Community Focus
Community Focus

Thread Tools
Old 02-25-2013, 05:23 PM #1
KronicCocker's Avatar
Join Date: Aug 2002
Location: 508
Annual Supporting Member
 has been a member for 10 years
Trigger replacement

Received a trigger in a deal I made for a viking and want to try putting it in. Any walkthroughs on this? I had the frame off, but was curious if I had to remove micro switch to get it out?
KronicCocker is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Old 02-25-2013, 05:28 PM #2
fsrxc1's Avatar
Join Date: May 2004
Location: mass
 has been a member for 10 years
Not if you pull all the screws in away from the switch, but some triggers work better with the switch flipped...depends on what kind it is
For all your AKA service and milling needs. Fully Authorized in the repair of Viking, Excalibur, and Merlin Markers.

Monster Paintball- I Bleed GREEN
fsrxc1 is offline   Reply With Quote
Old 02-25-2013, 07:32 PM #3
Dark Side
You will know the power
Dark Side's Avatar
Join Date: Mar 2007
Location: [redacted]
 has been a member for 10 years
Dark Side owns a Planet Eclipse Ego
Dark Side supports Empire
Depending on the frame, it should only be 2 screws or pins holding the switch in place. Either way pull it so it can't be damaged in the process. Then take a nail set and lightly tap the pin out. The whole process should take less than 5 minutes.

AKA Sidewinder / Autococker SCM 3 / MP4 Ram
in Gloss Black
Dark Side is offline   Reply With Quote

Thread Tools

Posting Rules
Forum Jump