Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 02-25-2013, 06:23 PM #1
KronicCocker
 
 
KronicCocker's Avatar
 
Join Date: Aug 2002
Location: 508
Annual Supporting Member
 has been a member for 10 years
Trigger replacement

Received a trigger in a deal I made for a viking and want to try putting it in. Any walkthroughs on this? I had the frame off, but was curious if I had to remove micro switch to get it out?
KronicCocker is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 02-25-2013, 06:28 PM #2
fsrxc1
 
 
fsrxc1's Avatar
 
Join Date: May 2004
Location: mass
 has been a member for 10 years
Not if you pull all the screws in away from the switch, but some triggers work better with the switch flipped...depends on what kind it is
__________________
www.destructivecustoms.com
For all your AKA service and milling needs. Fully Authorized in the repair of Viking, Excalibur, and Merlin Markers.
mark@destructivecustoms.com

Monster Paintball- I Bleed GREEN
fsrxc1 is offline   Reply With Quote
Old 02-25-2013, 08:32 PM #3
Dark Side
You will know the power
 
Dark Side's Avatar
 
Join Date: Mar 2007
Location: Charleston SC
Annual Supporting Member
Dark Side is BST Trusted
Dark Side is attending Decay of Nations VI
Dark Side is attending Decay of Nations VII
Depending on the frame, it should only be 2 screws or pins holding the switch in place. Either way pull it so it can't be damaged in the process. Then take a nail set and lightly tap the pin out. The whole process should take less than 5 minutes.
__________________
WTB

07/08 Ego Vici Board
Dust Black ShockTech AutoCocker snatch grip
Dark Side is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump