Originally Posted by Rebel_816
yes it would. technically it would still be facing out the "front" of the block, if you didnt notice its flipped around to where the ram is on the right side instead of the left like normal, as are all the other pneumatics. its all just made a U-turn.
the "front" of the frontblock is just facing the back of the gun. whole assembly's been turned around and he just drilled another VA hole into the side where the lpr's "intake" is.
Ha Ha.... no, that wouldn't work...... the pump rod would then be going out the front of the gun and if you notice the ram is on the same side as the three way. The ram was machined and tapped on the other end to accept another ram end cap, so basically the ram housing is just a tube now with two ram ends. I also machined the threaded portion of the front ram end cap off as it is not needed.
Also, the front block is not flipped, if you notice the three way is still the correct contour on the front block, just milled and tapped the right side of the front block to accept the ram.