As my sig says I have a G3 with the TechT, I recently purchased it broken from a fella on here since I have had the marker before I am working on fixing it, I have thoroughly cleaned and lubed the entire gun. I have the stock reg and have tried to use the gun with it, there is no leaks and the gun cycles fine but does not get to full velocity and when it fires the ball just rolls out of the barrel.
The velocity is set to the highest setting as well. I have a fresh battery installed just to be sure the noid was getting full power. I am using the Virtue Redefined OLED board just minus the OLED.
I also have a CP reg that causes the gun to cycle but when I back the screw out too far the noids click disappears and the gun no longer cycles. I am using a LP Ninja reg that is currently set to roughly Low 500 PSI output pressure, not sure if this is even related.
Wondering what you all though it might be...thanks.
-Bob Long Marq Closer | Zebra | Pillow | CP ASA & Rail | Lurker Turbo Spring | Lurker .678 & .684 Barrels | Ninja Pro Reg | Dye Rotor