[jjdogz]

Can any dye tech inbox me please my dm 13 keep leaking air from the bolt Area I change all the o-rings twice and still I get a constant leak I'm ready to send my dm back to dye Monday morning sharp

[jtguy2269]

where in the bolt assembly? replace the bolt sail oring again its 99% of the time the culprit

[jjdogz]

[quote=jtguy2269;78162978]where in the bolt assembly? replace the bolt sail oring again its 99% of the time the culprit[/

When I go to air up my dm13 I hear a leak in the bolt I change all those o-rings last night the first thing I did last night was change the o-rings on the bolt

[markkram]

Could be the solenoid gasket.

[Luxe4life]

I would make sure that bolt sail oring is rechanged again, try Over lubing and see if it will seal, if so wipe all the lube off and see if it will seal. Need any more info, I might be able to help just pm me.

But yeah most of the time it is that red oring on the bolt.

[jojo750]

where exactly is it leaking?
down the bolt?
above the trigger?
out the rear?

the easiest solution (and in my opinion, the worst answer) is change all the orings...
i try and change one oring at a time, then air it back up again. see if it still leaks. then change another.
its the best way to learn what orings cause which leaks, and in the long run makes you know your marker better.

good luck and post up some more info.
alot of people in this section can help you more than i can, but i can look at the basics and go from there.
install a new battery.
reset your regs.
fresh lube on the bolt.

[Draggunzz]

The pressure is off, I had the same problem and I changed all the orings and still a leak. So I did alittle research and backed the LPR out a little bit and it stopped.

[Splatkid10]

Ya as the above poster said, if you turned your LPR down for some reason, and you still hear a leak it may be the LPRs pressure setting is too low to fully hold the bolt back. Also check the troubleshooting guide of the manual at www.dyematrix.com it may be some help since you know exactly where the leak is coming from and we don't.

[ErinUSMC]

Lube might be it also. If u didn't lube it well it will leak

[jjdogz]

Thanks for all your help fellas but I'll go over everything again my lpr is fine I wanna stop this leak from the bolt arena

[METHORN]

Simple test air up your marker remove your barrel stick your finger down the from of your gun so that your finger covers the tip of the bolt if your finger stops the leak it is your bolt sale oring if not then you have a like from another part of the marker.

[iquadra]

Up your lpr and make sure the bolt sail o-ring is not over-lubed.

[jjdogz]

Some how I fix my dm 13 I change that sail o-ring my lpr is fine my reg is fine so far it's working fine I hear no leaks

[grss429]

Originally Posted by jjdogz

Some how I fix my dm 13 I change that sail o-ring my lpr is fine my reg is fine so far it's working fine I hear no leaks

Great if you have any more issue PM me or refer to my sig