Find fields & stores near you!
Find fields and stores
PbNation News
PbNation News
Community Focus
Community Focus

Thread Tools
Old 02-18-2013, 09:28 AM #1
imOGpb's Avatar
Join Date: Dec 2012
Location: san diego CA/ memphis TN
imOGpb has achieved Level 1 in PbNation Pursuit
imOGpb has achieved Level 2 in PbNation Pursuit
low pressure tank on sft??

does anyone know how using a low pressure tank on my shocker will make it perform and does anyone know off hand what smart parts put out for its operating pressure?
Bob long g6r for sale,
imOGpb is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Old 02-18-2013, 01:53 PM #2
proud gmax owner!!!
jim4130's Avatar
Join Date: Jul 2008
Location: woburn MA.
jim4130 plays in the PSP
jim4130 plays in the APPA D4 division
jim4130 is one of the top 250 posters on PbNation
jim4130 is Boss
Low pressure is fine you should have no issue.

The stock OP of a shocker is 180-220 psi. This will ofcourse vary depending on your bolt kit setup and oring tolerances.

Last edited by jim4130 : 02-18-2013 at 01:56 PM.
jim4130 is offline   Reply With Quote
Old 02-18-2013, 06:36 PM #3
JL1988's Avatar
Join Date: Jun 2012
Location: So cal
JL1988 plays in the APPA D4 division
JL1988 supports Ninja Paintball
I've always ran my tank at around 400-450 PSI with no issues.
JL1988 is offline   Reply With Quote
Old 02-18-2013, 10:24 PM #4
fishballer06's Avatar
Join Date: Mar 2005
Location: PA
Annual Supporting Member
 has been a member for 10 years
fishballer06 plays in the PSP
 plays in the NXL
fishballer06 donated to help Peyton Trent
fishballer06 supports DLX Technology
fishballer06 supports Shocker RSX
Consistency has suffered while using my SLP regs. I've also needed to turn up my reg pressure too. I don't recommend anything lower than 450.
fishballer06 is offline   Reply With Quote

Thread Tools

Posting Rules
Forum Jump