[Falconpunch01]

Has anyone had a stripped screw in there trigger ? If so how did you get it out ? The only thing I can think of is buying allen key with the ball at the end but for a .050 its hard to find.

Also anyone with a vitrue board would it be same dwell as a stock board ? Every since I got it its always been on 6 so I might try 12 tomorrow just wondering.

[jagarbosse]

The bolt needs a certain amount of ms's to cycle, regardless of what's printed on the board in the gun, so set it to whatever works. It you have the pooty bolt, I believe around 9ms is a good starting point, stock bolt is around 14ms I think.

[Ty29]

I bought my Luxe with 2 stripped screws. Your best bet is probably to find the smallest drill bit possible, I use a dremel usually, and get it out. They're so small though idk if you can find a bit small enough.

Buy a violent trigger or a replacement? :/

[Falconpunch01]

Originally Posted by Ty29

I bought my Luxe with 2 stripped screws. Your best bet is probably to find the smallest drill bit possible, I use a dremel usually, and get it out. They're so small though idk if you can find a bit small enough.

Buy a violent trigger or a replacement? :/

Can I remove the trigger with that screw stuck in there ? The pre-travel

[Ty29]

Yeah I believe so? If I had it in front of me I could tell you for sure.

Just separate the body and take it out. On second thought, do you even need to separate the body to get it out?