shocker sft manifold leak

mike_paintball · 02-14-2013, 05:58 PM

update:

well guys i got the oring monkey kit and replaced every oring (bolt and manifold) to size. i aired it up and the leak persisted. i then proceeded to take out the inserts and regrease them and put them back in. it sealed up, but only for a shot or two then it would start to slowly leak again. i messed with the depth of both inserts and eventually got it to seal completely. after dryfiring it a bit i ran some paint through it (half a pod) and it began to dump air again. any thoughts?

mike_paintball · 02-14-2013, 09:20 PM

Anyone?

speedy2k4 · 02-15-2013, 09:16 AM

Did you change the o-rings on the inserts?

mike_paintball · 02-15-2013, 02:01 PM

yes, literally every single oring i could find with the correct ones

Quote:

Originally Posted by speedy2k4

Did you change the o-rings on the inserts?

mike_paintball · 02-15-2013, 02:40 PM

also ive tried two different working manifolds and 3 working solenoids so they are definitely not the issue....

jim4130 · 02-15-2013, 03:16 PM

Its in your bolt kit for sure then. Since you have an oring monkey kit I'll almost guarantee your bag of 016 sail orings are mislabeled and are actually 015. Go through your kit and find the next suze up and try that.

mike_paintball · 02-15-2013, 07:05 PM

Quote:

Originally Posted by jim4130

Its in your bolt kit for sure then. Since you have an oring monkey kit I'll almost guarantee your bag of 016 sail orings are mislabeled and are actually 015. Go through your kit and find the next suze up and try that.

ill try it out thank you very much! is oring monkey not reliable in sizing?

jim4130 · 02-15-2013, 07:28 PM

Basing this opinion off the 3 shocker kits I've had come through my hands from them (1was my own 2 were friends) yes.

mike_paintball · 02-15-2013, 10:53 PM

alright ive put the proper 016 on the bolt, no fix. im literally at a loss with this gun..... ive done absolutely everything to no avail. i think my shocker days are nearing their end.

Apollo918 · 02-16-2013, 04:03 AM

Have you rebuilt your solenoid?

samuelkeesee12 · 02-16-2013, 07:20 AM

By the diagram on zdspb.com where is the leak coming from exactly?

mike_paintball · 02-16-2013, 12:47 PM

Quote:

Originally Posted by samuelkeesee12

By the diagram on zdspb.com where is the leak coming from exactly?

well i tried a noid that i positively know works and its leaking out of the middle right side where the noid meets the manifold