Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 02-14-2013, 07:36 PM #1
doctorstox
 
 
doctorstox's Avatar
 
Join Date: Nov 2001
Location: ct
doctorstox is a founding member
 has been a member for 10 years
Having a hard time removing valve from 2k+

Hey guys,

I am trying to pull the valve on a 2k+ rf body. I have removed the retention screw and lug nut. The valve will not budge. The valve seems to be aftermarket as there is not a channel cut through it. The area where the valve screw was is flattened but solid. And the valve is stainless steel. There is a small lip there and I have tried to push on it with a pick, but it has not moved.

Any advice here would be appreciated.
__________________
www.StraightPaint.com

Spectre - Always remember where you came from
Master Blasters - Always appreciate where you are
MasterBlasters.us
doctorstox is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 02-14-2013, 10:41 PM #2
addicted2dunes
 
 
addicted2dunes's Avatar
 
Join Date: Dec 2011
Location: Orcutt, CA
addicted2dunes has achieved Level 1 in PbNation Pursuit
Remove your front block, take a 1/8" allen wrench and put it through the front of the body and lightly tap on it to get the valve to fall out. This is a common problem and happens all the time.
__________________
"Originally posted by pumzele: If you don't know at least one of them (nuke, wedge, a2d, darkpolo, metalmover, demo222, ect.) I highly doubt you are a regular to this forum..."
addicted2dunes is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump