[DiskoBiscuits 2000]

Hey guys, I just bought the Etha. right out of the box I threw my 68/45 Empire tank in it just to check for a leak or anything wrong and sure enough there is a leak coming from the bottom part of the hose where it goes into the ON/OFF ASA. When I push the macro line to the right however, the leak stops. I was thinking maybe a roughly cut line? I don't really know wht to do though.

[convicted_knight]

Take of the macroline, try put a lil bit of grease on the groove on the tip off the macro line n put it back..

[DiskoBiscuits 2000]

Thanks mate

[CrusaderPB]

If that didn't work, you may need to tighten the macroline fitting. Or just replace the macroline. I normally see issues from one of the two.

[abenguyen]

Just sounds like a macroline leak. Try taking out the hose, and place it back in as far as you can push in. This is common on every marker with a bad cut hose.

[Nashorn]

Rather than replacing the fitting, you can just replace the #10 o-ring inside it. It will require a good hooked dental pic to get it out, but it at least saves you the cost of the entire fitting.