[blk mrkt]

Hey fellas,

Just wondering if anyone knows of a feedneck from any other marker would fit on a V1 Victory? I snapped the bolt off in mine and I want to see if there's any other options for replacements.

Thanks,

[gamer565]

Vice/g6r will fit.

Call blast to get a replacement.

[StyngRay2]

go to paintball gateway for one it is cheaper then blast.

[blk mrkt]

So that means that an empire nano feedneck for a vice should fit right?

[blk mrkt]

Originally Posted by StyngRay2

go to paintball gateway for one it is cheaper then blast.

And ansgear has them a little cheaper than that

[Coenen]

Let me guess, you over-tightened the bottom screw and it snapped on you? I did the same thing.

Call BLAST, describe what you did, and they should be able to sell you the feed tube and installation screw only. When it arrives, just swap over the clamp arm and hardware from the feedneck you already have, and you're done. I think it cost about $25 out the door.

[blk mrkt]

Originally Posted by Coenen

Let me guess, you over-tightened the bottom screw and it snapped on you? I did the same thing.

Call BLAST, describe what you did, and they should be able to sell you the feed tube and installation screw only. When it arrives, just swap over the clamp arm and hardware from the feedneck you already have, and you're done. I think it cost about $25 out the door.

Yep! That's excactly what happened (I did the same thing with the left eye screw, they should switch to larger screws) although it didn't help that when I got it the screws had a little rust on them. But I think I'm just gonna replace the whole thing the anno is wearing off. Thanks for the advice