[Ninjitsu232]

Got a Trilogy Pump the other day and it wont chrono over 260.I have tried Co2, and HPA and it just wont make it. I tried other springs with the IVG all the way in but still no uograde. Any ideas what it could be? or recommendations for another spring to try?

Thanks!

[noclue119]

Originally Posted by Ninjitsu232

Got a Trilogy Pump the other day and it wont chrono over 260.I have tried Co2, and HPA and it just wont make it. I tried other springs with the IVG all the way in but still no uograde. Any ideas what it could be? or recommendations for another spring to try?

Thanks!

Your pressure is too high. Lower your input pressure. Get a reg tester, set your HPR at 300-350 to start.

[Ninjitsu232]

Trilogy doesn't have a reg on it. And I have tried using a slp reg (from my g6r) and it wouldn't chrono over 230

[bac0n]

Investing in a regulator will help, but it also depends on your valve spring and main spring.

I recommend this Trilogy LP kit: http://paintballgateway.com/wgptraulowpr.html

Since you're running a gas through with a full pressure out-put, it's nearly impossible for the stock main spring to open the valve properly to achieve your desired FPS.

[noclue119]

Originally Posted by Ninjitsu232

Trilogy doesn't have a reg on it. And I have tried using a slp reg (from my g6r) and it wouldn't chrono over 230

Some has Adjustable regulators. You just have to take off the bottom piece to adjust the pressure.

[Castro #66]

Most don't have regs, and those that don't also lack a high flow valve. They require a spring replacement at the least to reach the FPS requirements you're looking for. The valve kit mentioned above will work well on the lowest Trilogies, but is nearly identical to anything in the "Pro" and "Select Fire" guns.