[Cromer611]

So you got a new board sent to you, and it still didn't work? I'm starting to believe its something obviously not put together correctly.
With paint, air, and a loader it still won't fire?

[e_b_l_s]

Nothing works. Its not the main board that's faulty. Its the sensor board that they're supposed to replace.

[fishleg]

This might sound stupid but why not completely remove grip frame and manually press the microswitch, button behind might be stuck down aswell.

[private_silver]

"sensor board" being eye board I'm assuming. Not to say its wrong to have waited this long, but due to the time constraints you have being in Asia, why not just buy an aftermarket at this point? If you go buy a virtue eye board for the axe, it's essentially replacing the same thing, and probably cause a lot less hassle for you.

[fox5100]

Does the gun shoot with paint

[BNelly13]

A little late, but if I still have an optimus board in my axe can I get the free upgrade to a shockwave board?

[Gbxdillon]

Just call kee and say its broke they sill send u new board and 99% sure it will be the shockwave

[BNelly13]

Thanks man.

[Buster Hymen]

Originally Posted by fox5100

Does the gun shoot with paint

[Ss7]

Originally Posted by BNelly13

Thanks man.

No, what you are hearing click is the micro switch, not the solenoid. Does your gun air up properly? I think to turn the eyes off, you turn the gun on with EYES ON and click the button once. the solenoid should be fairly loud. If no, make sure your solenoid is magnetized, there is NO paint or dirt underneath the microswitch (yes it happens often) and make sure that your gun is aired up.

Respond and let me know what happens.I can help with further assistance if needed.

[dmpb]

Originally Posted by e_b_l_s

I wanted to try dry firing my axe and i knew i had to turn the eyes off. Followed the manual to hold the trigger down while powering up the axe.

The green LED flashed twice rapidly, clearly showing that my eyes were off.

But nothing happened after squeezing the trigger. Am I doing it wrong?

did this ever get fixed? I picked up an axe about a month ago. when i turn the axe on with the button on the front grip the gun activates and i am greeted with the intermittent flashing green light. if I want to turn the eyes off all i have to do is push the power button again once quickly and then the green starts flashing rapidly (not in pairs but a consistent flash).

if i hold my trigger down when turning on the gun it enters programming mode.