[jeepmiller09]

Tuning my 3rd Gen intimidator I couldn't get it past 250fps at 100psi ( i know too high) on the lpr. I upgraded the ram and the spring on the poppet to a lighter spring. I thought it was bc of the spring. I was about to tear it apart to replace it with the stock one and for some reason i checked the tightness of the regulator and it was still kind of lose. I took the trigger guard off and turned the regulator till one of the O rings was bulging out. Then did a quarter of a twist back. I then lowered the lpr to 60 and i was shooting at between 300 and 290.

My question is why am i jumping around so much with the fps? out of 5 shots it was 300, 289,295,292,299. Is this normal?

I am not a big fan of the elbow that doesn't pass the trigger guard unless i remove it is there a good aftermarket Regulator that works well like the CP Gen 3 Inline Regulator, or 360 Torpedo Inline Regulator?

Upgrades:
Eigen Ram w poppet spring
CP adj ram cap
BL 2 piece barrel
Empire 1.5 board
Old ASA (not sure what kind.) Want the new gear drive asa


Thanks,
Miller

[gamer565]

Those numbers are pretty good. Alot will depend on the paint quality and paint to bore match.

[jeepmiller09]

Ok so the Reg is fine then i don't need to change it out. Any idea on a good trigger guard so i can twist this reg with out taking off the guard?

[tim2thousand4]

I'd set it and forget it. Lower that LPR a bit. No need to be over 80.