Originally Posted by GOG Paintball
We do not have Canadian programing. The first 2000 or so extcy's had the old programing on the blackheart boards and thats what it sounds like you have. If you would like to have the new programing installed on your board you can send it into us and we will reflash your board with the newest software. In the mean time I believe this manual should be close to the programming on your board. http://paintball.smartpartsparts.com...20M anual.pdf
It seems I have bigger problems then just the firing mode issue. I had set the dwell for the recommended HPA setting, got the correct confirmation flashes, powered it off but when test fired there was all sorts of inconsistency. When I checked the settings again it seems it defaulted back to 5ms which isn't even the correct default time. I set the dwell again, proper number of confirmation flashes again, powered off but when I powered back on and checked dwell again it was back at 5.
Will sending the board in to be reflashed correct this or am I back at the possibility of a defective board and having to replace it? I have removed the board to ship it but if you could provide me with the details of where I send it and the proceedure to follow that would be great. I can't seem to find a cost for an eXTCy replacement on your website. Would it be the same board as the eNVy?