Hello!
I recently bought a used SLG 08 model from someone on craigslist who said it needed a new oring and it would be good to go. It was $40 so I took the chance.
I replaced the said oring, greased the bolt, turned on the gun, and hooked up the tank. The bolt flew back into the ready state, but as soon as I pull the trigger the gun just starts firing like it is in full auto and usually doesn't stop until I unscrew the HPA tank.
I checked all of the orings on the bolt, and in the regulator. I turned turned the regulator adjustment all the way in and then out 4 1/2 turns as I saw someone else suggest. Still the same problem so I turned it out another turn and still had the same problem.
I checked the board settings and it was set to semi auto, 15 bps, 15 trigger sensitivity so I changed it to 10 bps and 20 trigger sensitivity and still no change.
I have tried running it with very little grease and a little oil and also with a lot of grease. Same effect both times.
If need be I can create a video in the next couple of days so you can see what it happening. Anyone had this issue or know what the fix is?
FYI here is the manual.
http://www.dyematrix.com/manuals/Pro...SLG_Manual.pdf
- I also posted this in the SLG forum.
