[Icydeadpeople]

hey guys, i was out at the field last weekend, trying to test out my project dynasty shocker, i turned it on fired it a couple times and then tried to adjust the board settings but it wouldnt turn off after i changed the settings. i unplugged the battery from the board, plugged it back it and tried to turn it back on but no dice, i put the board in another shocker and it works just fine, so its a problem with my ccm frame on/off button, how do i go about fixing that?

[amossbur]

This happened to me, but with my Logic frame. When I reinstalled the wires connecting the upper and lower boards, it turns out they were pinched between the power button actuator and the actual power button. My gun would turn on, but not turn off. I took the same steps you did and discovered the issue.

When you put the frame back on, just make sure that the wires go all the way through and are not pinched.

Hope that is the only issue!

[kool_aid22]

Yep and the board wires too will cause the power button to stick

[Eagledsm]

After numerous ccm frames i have owned, usually a pinched wire is the culprit. But I did have one frame that i had to actually move the power button on the board for the on\off to work correctly.

[d-r0ck-1489]

ive experienced all of the above. if it is a problem with on/off frame button being a lil too short you can always glue a small piece of plastic to the end to lengthen it instead of moveing the button on the board ( if your uncomfortable with soldering)