|
pipe question
I picked up two brass eagle talons jus to mess around with during the off season. I want to mod them for constant air feed. I picked up two 1/8npt 6" long galvanized pipe nipples. I am just kind of worried about the pressure rating. According to what I looked up online for the pipe nipples they are rated at 150psi WOG @ 150F. Not exactly sure what WOG stands for. What I plan on doing is removing the puncture pin from the valve body, drill out the puncture pin hole to thread in a 1/8npt. Drill out the center of the black knob that you would tighten to puncture a 12gram co2 so the nipples I have fit through nice and snug. I have a dead on asa that I am going to use just need to pick up another cheap asa for the other marker. Am i over worrying, I've seen this method done in several photos of talon mods.
|
