Originally Posted by speedy2k4
If the wires are broken, just clip out the broken section, strip the insulation back a bit and solder & shrinkwrap the ends. There is usually some wire to spare on those harnesses.
If the wire can't reach the socket in the board after doing that, buy a new harness and solder it in. I may have a spare.
Yeah I know to shrinkwrap the ends, etc, and I have the tools for it. I have plenty of wire, so not worried about that.
My question about doing this though, without getting a new harness (and I simply haven't tried this yet, mainly due to time constraints), is can you reattach the wires to the male connector that plugs into the socket on the board?