[ewok11]

#1. Pressures set to 75/165. Dwell 6, Lp poppet, techt bolt.
Insane first shot drop. After first shot, shooting around 295. Nearly every single time I don't shoot for thirty seconds the first shot the bolt won't cycle completely barely pushing a ball through the barrel. Next shot fires. Chopped ball in barrel. Any solutions? Any one experience the same thing?

#2. (Different gun) Pressure card says 75/175. Set it that and gun won't cycle. It won't fully cycle till lpr is around 120. I know this is way too high. What could cause this? Why won't it work at stock pressures?
Thanks for the help in advance

[G00DFELLA]

Could be an issue with your pressure tester or tank....also gun 1 sounds like the reg isn't recharging properly, clean it.

[gamer565]

#1: Replace the rear ram oring and be sure to use the correct lube, and maintain the regs.

#2: Make sure the dwell is at 6ms, replace the ram orings and be sure to use the correct lube.

If you have not, replace your gauges with better accurate ones.