[SoCal Guy]

i tried to squeeze tadao into a 45 grip..and almost destroyed the board. do people know what board actually fits into a 45 grip (and where i can possibly find such board)?

thanks.

[gwhetzler]

Tadao, vaporworks chaos and the old school stock boards that came with the gun 12 or 20 etc chips.

[DyE 5³]

You're talking about the aardvark .45's? Tadao will fit in there, but like you I didn't wanna mess it up so I had mine installed by Duane Parsons when I had my eyes installed

[gwhetzler]

Hmm I think its a pain in the *** to get them in but they do fit and you could trim them up a bit to get them in too.

[BonesJackson]

Alright, here's a complete list:

• All revisions of blind LED boards
• Tadao 4.0*
• Tadao 5.0**
• Vaporworks Chaos

*Requires you file/sand down the frame at the top-most microswitch solder point. Also remove the board's chip before installing.

**Requires you to bend the 'tower' down, and also remove the chip. WARNING: IF YOU INSTALL AND REMOVE THE BOARD MULTIPLE TIMES, THIS WILL WEAKEN THE SUPPORT LEGS ON THE 'TOWER' AND IT WILL LIKELY SNAP OFF. Then you'll have to send the board off to Will, who will tell you, "The component that is broken off is the mosfet, which controls power to the solenoid. I have extras, so as long as there's no permanent damage to the PCB, I can repair it." <--- direct quote from an email after I broke my board.

[MaToCa]

Originally Posted by BonesJackson

Alright, here's a complete list:

• All revisions of blind LED boards
• Tadao 4.0*
• Tadao 5.0**
• Vaporworks Chaos

*Requires you file/sand down the frame at the top-most microswitch solder point. Also remove the board's chip before installing.

**Requires you to bend the 'tower' down, and also remove the chip. WARNING: IF YOU INSTALL AND REMOVE THE BOARD MULTIPLE TIMES, THIS WILL WEAKEN THE SUPPORT LEGS ON THE 'TOWER' AND IT WILL LIKELY SNAP OFF. Then you'll have to send the board off to Will, who will tell you, "The component that is broken off is the mosfet, which controls power to the solenoid. I have extras, so as long as there's no permanent damage to the PCB, I can repair it." <--- direct quote from an email after I broke my board.

Wanna know how I did it and it dropped in......lol. I took it to a craytex wheel and ground down the solder points on the back, fell right in........lol.

[SoCal Guy]

anyone knows how i can buy vaporworks chaos board? seems like paintballtrader.com is not answering emails anymore..

[Vegard]

Get a tadao and sand it a bit, Chaos boards are not something you want unless you like quirky boards with no support.
Harju would probably be your best bet though.