[pikebruin]

I just got this ripper victory and shots great if I am not on the trigger. As soon as I really get on it, the marker goes full auto and air is just blowing out of the barrel. I set the board back to the default settings and I cleaned the bolt but the same thing happens. Any ideas what it could be.

Yes I read the manual and yes there is a spring on the trigger.

Thanks in advance for your guys help.

[andyschein]

Originally Posted by pikebruin

I just got this ripper victory and shots great if I am not on the trigger. As soon as I really get on it, the marker goes full auto and air is just blowing out of the barrel. I set the board back to the default settings and I cleaned the bolt but the same thing happens. Any ideas what it could be.

Yes I read the manual and yes there is a spring on the trigger.

Thanks in advance for your guys help.

Did you happen to accidently put dow 55 on the donut?
Is there any nicks on the Brown donut?
What are your pressures?

[Nolan Clemons]

Replace the front blast guide o-ring and try it out after.

COPY AND PASTED FROM LAST THREAD, (props to that guy for knowing his ****.)

[pikebruin]

No Dow on the donut. I tried replacing the front oring as well on the bolt. Unfortunately I don't have any air left to test it.

Thanks for the help guys.

[GoblyGoop]

Try bringing out your trigger a little. If its set in too close, it might register more shots than pulled and shoot auto for a string of like 10 balls. I've had a similar issues and this fixed it.

[pikebruin]

I will try that as well. Thanks for the help GoblyGoop

[a.m.f.g.23]

are the balls barely shooting out maybe like 10 feet TOPS? its the spring on your bolt...either replace the spring or take your bolt apart and pull the spring apart slightly not too hard...i dont remember why it causes this (someone told but but i dont remember someonethin about the spring not being strong enough to cycle the bolt) but my i had the same problem with my v2 and my friend had it on his v1

[paintking22]

From what I know, the gun goes into a bolt stick mode where it will attempt to free up the bolt. Lube the blast guide and make sure to lube the rammer so that it can slide easily through the inside of the blast guide, this fixed my similar problem.

[yusosalty]

check your lpr i had the same problem

[yusosalty]

Gone

[turmoil]

I had a similar issue. Backing out the trigger adjustment screws so the switch activates 1/2 - 3/4 of the way through the pull fixed it.

[lopez17]

Sounds like the donut.

[Knucklez]

Originally Posted by turmoil

I had a similar issue. Backing out the trigger adjustment screws so the switch activates 1/2 - 3/4 of the way through the pull fixed it.

this.

[norcal-baller]

sounds like trigger bounce...