[Paint_hore]

Originally Posted by HarrisonJones

thats clearly rub

Girly-faced cheater!!!

[DarkRipper]

The best part of Harrison's pictures is the ghetto electrical tape mount for his 300 dollar R7, lol.

[Paint_hore]

He too gangster to do it right!

[iquadra]

Ghetto mounts for the win... Not to mention in my case a ghetto camera haha

[HarrisonJones]

lol the damn mounts are different, between dye and PE guns so i just had to tape it on there lol

[iquadra]

Hey a quick question guys, does anyone in here shoot a billy wing's nt at a field that requires you to shoot below 280 fps?

Mine I picked up is sitting right at 300 (with the green spacer) and I don't have the next size spacer which would be the yellow. Is my best bet going to be slapping the red spacer in there or lowering the reg a bit? Or even just buying the yellow spacer?

I haven't checked the reg pressure yet with a tester, but I've heard nt's can get super finicky when sitting at the wrong pressure so I wanted to ask before I mess with anything.

[DarkRipper]

It's official, the Seed kit is better than the Virtue Rotor board with RF kit.

[Blusylver]

You made this official?

[Paint_hore]

I've never tried either so I cannot comment.

[Blusylver]

They are both for rotors so naturally they are blah

[DarkRipper]

Originally Posted by Blusylver

You made this official?

I'm about to buy a news up :p

[erikguti]

Seed kit helps a lot the rotor!! i have one in an old rotor!! but i dont used the rotor anymore since the Z2!!!!

[DarkRipper]

Originally Posted by erikguti

Seed kit helps a lot the rotor!! i have one in an old rotor!! but i dont used the rotor anymore since the Z2!!!!

The Z2 is WAAAAAY too complex.

[Blusylver]

Z2 is the best out.

[DarkRipper]

How do you figure

[Paint_hore]

New spire colors look sick!

Its still too wide looking for my tastes.

[Blusylver]

Easiest to load, to clean it never jams. And you always know when its on since it uses a toggle switch, and not some cheap light that burns out after 2 months (rotor)

Down falls are battery life and magnets holding the speedfeed/lid

[Blusylver]

New colors???? Grrrrr

[Paint_hore]

Ive had the same Rotor from the week it was released about 3 (or 4?) years ago....my light still works fine. My other Rotor is over a year old and the light is fine there too.

Honestly I never heard of the issue from anyone that plays around me and they all rock Rotors.

Also have a Prophecy in case I get jams but I never use it.

[Blusylver]

I have owned 4 or 5 rotors and i think the light worked in 1 of them

[DarkRipper]

Originally Posted by Blusylver

Easiest to load, to clean it never jams. And you always know when its on since it uses a toggle switch, and not some cheap light that burns out after 2 months (rotor)

Down falls are battery life and magnets holding the speedfeed/lid

No freakin way is it easier to clean than the Rotor. You need a mechanical engineering degree to put the darned thing together right.

I'd say ease of loading is the same as the rotor, don't know how it could be easier?

Rotor with Seed supposedly never jams. So far it hasn't for me.

I'm meh about toggle switch vs button with light...

I agree about the magnets holding the speedfeed, full on wtf on that.