[mattbutcher]

basically what the title says. my trigger is sticking like no tomorrow. i keep on messing around with the set screws and the magnet tension to try and stop it but nothings working. it's 100 time worse though when shooting left hand so im guessing it has something to do with the set screws and one side is to far in and it's rubbing like crazy against the frame. if you have any other ideas, please let me know

[specopsdeath2]

Unscrew the set screws, and then tighten down the two screws holding the trigger in place.

Make sure no wires are in the way of the trigger also. The eye ribbons could be getting caught between the body and frame so check this as well

[digital sol]

Originally Posted by mattbutcher

basically what the title says. my trigger is sticking like no tomorrow. i keep on messing around with the set screws and the magnet tension to try and stop it but nothings working. it's 100 time worse though when shooting left hand so im guessing it has something to do with the set screws and one side is to far in and it's rubbing like crazy against the frame. if you have any other ideas, please let me know

Id just pull the trigger and take a look at the set screws/pin. Did you take a finger shot recently? Nothing worse then a slap on the fingers and gunk inside the frame/trigger area....

[Pure Liquid Hell]

is everything clean? dried paint?

[mattbutcher]

Originally Posted by Pure Liquid Hell

is everything clean? dried paint?

everything looks completely clean

[mattbutcher]

Originally Posted by specopsdeath2

Unscrew the set screws, and then tighten down the two screws holding the trigger in place.

Make sure no wires are in the way of the trigger also. The eye ribbons could be getting caught between the body and frame so check this as well

ok thanks

[mattbutcher]

nothing has seemed to fixed it yet

[mattbutcher]

if anyone has any ideas, they would be greatly appreciated

[Naumoff42]

Have you checked the pin and bearing?

[mattbutcher]

the trigger isnt sticking as much now. i had to re adjust the set screws. the right side was in to far. thanks

[uranjack]

Try to adjust each screw the same, Start out having each side flush to the trigger frame. Then adjust each side little by little. A problem I've seen is that people don't get the screws actually in the right place in the trigger.

[mattbutcher]

my trigger is finally not sticking! thanks everyone