[Word?]

Yeah the dualies were for form, not function so much. I'm just gonna take the left gauge off and volumize the top reg. I just love the look.

And yea cwag I actually looked through your thread before I started my project.

[Cracker with a gun]

Originally Posted by Word?

Yeah the dualies were for form, not function so much. I'm just gonna take the left gauge off and volumize the top reg. I just love the look.

And yea cwag I actually looked through your thread before I started my project.

dualies are still cool on a 2k2 body but not in any way needed, plus the alias or aka lpr are better

i hope to have mine all done right before or right after xmas

[lopez17]

Originally Posted by Word?

Anyway, I was unaware that dualies and alias frames did not mix. When I mocked up everything at first, the barb wouldn't fit inside the frame. So after looking it up with no results I did some custom work.

http://imgur.com/rpVYJ.jpg


Weird, because I'm almost positive I've seen 2k5'd timmies with alias frames and dualies .

Next update when I get my last packages in.

It can be done but usually it requires a dremel job on the front of the gripframe to eliminate the point where the frame comes in contact with the barb on the dual block. I've bought a few gripframes over the years (sadly I don't have any at this point) that have been dremeled out to enable this.

I'd usually recommend that you have the body tapped for an Alias Block by BLAST. The Alias block is superior to what you'd get with a 2K2 or Dual reg block anyways. It volumizes a significant amount of air and the grub screw holds better than the 2K2 style screws that have a tendency to back out and lead to loosened blocks.

From there, just get a new noid, wiring harnesses and a 2K5 board and you'll be set.

[Word?]

Hey

Hey

You know how long I've wanted dualies on a Timmy? They're staying on

[Word?]

Quick question guys

I have a CP adjustable ram cap, and an eigenram. In the instructions it says to cut the bumper if you have a bumperless adjustable or w/e. And from my understanding bumperless means it has a rubber bumper to adjust it (like the hybrid ones) but the CP uses a brass attachment.

So should I cut the bumper on the eigenram?

[lopez17]

No.

[Word?]

Welp.

Got my body and ram sleeve today. Minus the cup seals I said I'd pay for but was told "no no, I'll throw it in!" The body doesn't even have the gz emblem milled in. Eventually I called back and talked to Zach about my missing cup seals and was told in a nutshell we don't have them anymore we have to pull them out of g6r's blah blah blah

Definitely upset.

.......got a free feed neck though.