Originally Posted by PumpinBallerSims
Thank you sir just the answer was looking for... How many shims would I need to run to get to -+300 output?
I don't think the Pure Energy LP kit can get you down that low if I remember correctly. I think it will get you down to only 450psi or so - and it is not
a matter of how many shims - it is a matter of replacing the HP internals of the reg with what comes with the LP kit. Those are your only 2 options - HP at 850psi or 450psi with the LP kit. However, if you make a pressure tester, you can probably mess around with removing shims from the LP kit to see if you can get the pressure lower BUT I'm not sure what that will do to the consistency of the reg output or the recharge rate.
Graphite Dangerous Power REV-I
– TechT bolt engine, REV-I & Disruptive barrel kits, Prophecy V2 w/ Empire feedgate, Crossfire SS 68/4500
Maroon and Polished Aluminum Dangerous Power Threshold
– 7th Element board, TechT bolt engine, magnet trigger kit, REV-I PMD, Sly Dual Carbon barrel kit, Prophecy V2, Crossfire SS 68/4500
Black and Silver Dangerous Power F8
– APE Rampage board, VS bolt, magnet trigger kit, F8 gauge, REDZ barrel kit, Halo B w/ Exalt feedgate, PMI 68/4500
Polished Aluminum and Red Dangerous Power F8
– Virtue board, VS bolt, magnet trigger kit, Halo B w/ Exalt feedgate, PMI 68/4500