[PBMT]

Heh, bet that grabbed yer attention. Wouldn't it be great if his stuff came out that quick

Anways, after looking at the pics of the DAM fuse engine (or whatever we're calling it) I noticed that even though the dump chamber area has the slots where the air flows to the bolt in the old Top Hat spot instead of on the Bolt Cap side as before it may still be possible to develop a similarly working EigenRing. It would just mean that the EigenRing would move in the opposite direction as before, it looks like it would also travel further. One down side I guess would be that it is additional mass moving forward with the bolt now instead of backwards in a standard EigenRing so we would lose the "Recoil canceling technology". See my super high tech 3D rendering of what I believe it would look like below



What do ya think, since it is the holiday season should we give him a couple extra days and say we want some prototypes out by Jan 3rd?

j/k no pressure

[CrazyHarry]

I'm doubtful that it will happen... the original Eigerings aren't selling very well, so I doubt that he'll invest any more time or effort into upgrades for the fuse bolt.

[Lurker27]

Could be possible with one of the other existing geometries, though.

[ProtoSkillz]

Im sure all the woodsballers and milsim guys would appreciate an Eigenring.

[cmdrsuds]

Almost got and Eigenring for my PM7 but never did. Saw a couple pics of shredded ones and didn't end up hanging onto the gun for too long.

TechT will likely release a bolt which always gets you a few more shots then add a tophat mod, electrical tape to the black stem, and you should see a nice improvement... that is if the current Eigenrings don't work.