[duckys1]

Hey folks. I just recently replaced the Noid with a brand new one from kee due to the issue of it taking a couple shots to get going. After this i aired up the axe and it cycled fine.. once i put paint in it it will not even get a ball out of the barrel. I havent checked the battery yet and i know thats a possibility. Any other suggestions on what to check?

[SNAKESNIPER (Banned)]

the battery?

[duckys1]

lol thanks... im aware of that... im at work so im just trying to get some ideas to check once i get home.

[EmpireTech]

Try resetting the solenoid if you haven't done that yet. Sometimes that can help.

[Dirty J]

Make sure the solenoid plug it fully seated into the upper board. If not positioned properly, the plug can be disturbed when attaching the frame, causing a poor connection.

[duckys1]

Originally Posted by EmpireTech

Try resetting the solenoid if you haven't done that yet. Sometimes that can help.

how would i reset the solenoid? There is a button on it correct?

And thanks about the wire being secured. I will check that as well.