So I have been reading on elector-pneumactic triggers and I am a bit confused by it. What will I need to do to make it work. Got a X-valve on the way with RT on/off.
there are alot of options for that. the most obvious being the ego-mag conversion. which you would need a 05 ego frame, pneumatic ram, an SMC noid and some minor machining.
or you could go the scenario dreams route with the Tboard but youd be making everything from scratch
__________________ Boneyard Paintball in Plymouth, WI Stinger Paintball Designs for your custom grips
"Reminds me of the kids that bolt on exhausts, wings and vinyl cutouts onto their rice mobiles and then hate on a ground up resto rodded 69 Camaro" -OPBN
Or you could use an Invert Mini frame... Bolts up, a ton of room, board resides in the foregrip, just need a drill press and a soldering iron to add a micro switch.
Finally got all the o-rings replaced with a new set from AGD and a spacer kit that I found. She shot beautifully!!! Better than expected. I used a 4500psi tank with an operating pressure of 1100 psi. Now I'm just waiting on my X-valve/lvl 10 kit to arrive. If I get a marker that I'm eying with an electronic trigger with the classic valve, I will throw the new valve in it.
Just got my Lvl 10 bolt and X-Valve with R/T on/off. LOVING IT!!! Only thing I have left to do now is get a different trigger frame (may be original) and re-finish or polish the body.
but youd be making everything from scratch
