Find fields & stores near you!
Find fields and stores
PbNation News
PbNation News
Community Focus
Community Focus

Thread Tools
Old 10-26-2012, 07:53 PM #1
I choose you!
swampster123's Avatar
Join Date: Jan 2012
Location: San Antonio
swampster123 posts videos on PbNation
swampster123 has achieved Level 2 in PbNation Pursuit
swampster123 has achieved Level 3 in PbNation Pursuit
Pure Energy LP conversion

I bought a LP conversion for my Pure Energy tank. I have the blue reactor reg btw. And I got 10 curved shims with 2 very thin circular washers. On the directions is says 12 this normal? Am I missing some?? How can I tell what my output pressure is? I have a G6R so need it low pressure....Do i use both small washers or neither or one? Thanks, Tyler
swampster123 is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Old 10-26-2012, 08:12 PM #2
Will B/S/T Souls
Tabris17's Avatar
Join Date: Jan 2006
Location: Connecticut
 has been a member for 10 years
Page 1, right side half way down to the bottom has everything you need.

Those washers are for fine tuning your pressures. They're included in the count to make 12 but it's 10 curved shims and 2 adjustment shims which are flat washers. Same you'll find in your reactor reg with the HP, 10 curved and 2 flat.
If you need further help and the ultimate sticky doesn't help then contact paintball solutions which is tech support for KEE/Empire.
Tabris17 is offline   Reply With Quote
Old 11-14-2012, 05:50 AM #3
What's a 12ie?
Oldandsneaky's Avatar
Join Date: Aug 2012
Location: Port Orchard, WA
Annual Supporting Member
Oldandsneaky has achieved Level 3 in PbNation Pursuit
Oldandsneaky supports Ninja Paintball
Thanks for the info. I had to change a bonnet and a belleville washer fell out of the regulator. This helped me re-assemble the stack correctly.
Oldandsneaky is offline   Reply With Quote

Thread Tools

Posting Rules
Forum Jump