Originally Posted by mrbill53
Thanks. That means I didn't loose one. Back to the drawing board.
VELOCITY IS NOT CONSISTENT
• Make sure the paintballs you are using fit the
barrel good and are consistent in size. The stock
barrel with the 2012 DM Series is .688 size.
You should be able to blow the paintball through
the barrel but they should not roll through the
barrel on their own.
• Remove the bolt kit and re-lube it. Change any
O-rings causing a lot of friction. Make sure #014
O-ring in bolt tip is in place and in good condition.
• Raise the dwell.
• Change the battery.
• Check that the Hyper3™ regulator is working
correctly and that the pressure is consistent.
A separate regulator-testing tool is available for
this. If needed, dis-assemble and change worn out
Also change the two tail orings on the bolt, make sure your reg isn't creeping, change your reg seat and the 010 oring on the adjuster screw