Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 11-09-2012, 01:47 PM #1
Name_Pending
 
 
Name_Pending's Avatar
 
Join Date: Jul 2003
 has been a member for 10 years
My Micromag is feeling a little naked without a foregrip!

So I have an old gen 2.5 micromag and I have been scouring the bowels of the internet to find a vertical ASA or a foregrip to fit but have had 0 luck so far. PTP has 0 in stock and wont make any more and I cant find someone to sell me a used one so I think I may try and rig one up myself!

Has anyone here had any experience jerry-rigging something up? I'm looking for some guidance or hopefully some photos to get me started. So far I was thinking about taking a spar mag ASA and grinding a gap for it to slide on the body and drill a hole for the screw but I'm not too sure about my machining skills and getting tht screw lined up with the body's hole.

Thanks guys, open to ANY advice on the subject.

Name_Pending is offline   Reply With Quote
Old 11-09-2012, 07:26 PM #2
luke-AO
www.lukescustoms.com
 
Join Date: Oct 2005
I have a few left, (down at the bottom)>

http://www.lukescustoms.com/page0007.htm
luke-AO is offline   Reply With Quote
Old 11-10-2012, 06:20 PM #3
Name_Pending
 
 
Name_Pending's Avatar
 
Join Date: Jul 2003
 has been a member for 10 years
Ok cool. Will these fit the gen 2.5? I heard that the 2000's use a different foregrip? Have any left that match this angled milling?
Name_Pending is offline   Reply With Quote
Old 11-10-2012, 06:41 PM #4
luke-AO
www.lukescustoms.com
 
Join Date: Oct 2005
As far as I know the FG I make will fit this.

Last edited by luke-AO : 11-11-2012 at 12:11 AM.
luke-AO is offline   Reply With Quote
Old 11-11-2012, 03:46 AM #5
Name_Pending
 
 
Name_Pending's Avatar
 
Join Date: Jul 2003
 has been a member for 10 years
Ok great I will keep it in mind
Name_Pending is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump