Ok guys.. I have always wanted to completely
piece a Shocker together from scratch & I finally have the means of doing it. I have been collecting random Shocker parts for some time, and now I am about to embark on my project.
Here's what I am looking at so far. Please let me know of any input you may have to make this better!
& now for the pictures!
The body I am looking at using is this Dynasty SFT ('05 I believe?) It was milled for NXT BB eyes by CS. The body overall is in great shape for it's age!
I am dead set on using this CCM RIP frame on this project. I also have a silver Dynasty SFT frame as well as a normal silver SFT frame. input on my choice of frame will be heard..
For the VA and the regulator I have a black Dynasty VA and a Bob Long 360 Torpedo regulator. I have a couple more VA's and an old school Torpedo regulator as well as a black CP regulator I can use.
For the bolt I will be using a NDZ low pressure spring modded bolt guide, Pooty flat face bolt, with an ultra low pressure firing can. The whole bolt is Pooty except for the bolt sleeve.
I still need to get a rail for the ASA I will be using. I have also contemplated getting the CCM frame milled with a dovetail if that is possible?
These next parts are new replacement parts I will be using as internals. Nothing too special about these really. New noid with upper board, BB NXT eyes, wiring harness, and NDZ stainless steel high flow ported manifold.
I sent a Virtue OLED board I had laying around off to Virtue for repair earlier today, which I will be using on this gun. Once I have decided on all the parts I will be using I am planning on sending this bad boy off to get a clean anno so it really stands out! I will be continually updating this thread as this gem develops! Thanks for looking and anyones input will be heard!