Find fields & stores near you!
Find fields and stores
Zipcode
PbNation News
PbNation News
Community Focus
Community Focus

Reply
 
Thread Tools
Old 10-26-2012, 08:53 PM #1
swampster123
I choose you!
 
swampster123's Avatar
 
Join Date: Jan 2012
Location: San Antonio
swampster123 posts videos on PbNation
swampster123 has achieved Level 2 in PbNation Pursuit
swampster123 has achieved Level 3 in PbNation Pursuit
Pure Energy LP conversion

I bought a LP conversion for my Pure Energy tank. I have the blue reactor reg btw. And I got 10 curved shims with 2 very thin circular washers. On the directions is says 12 shims.....is this normal? Am I missing some?? How can I tell what my output pressure is? I have a G6R so need it low pressure....Do i use both small washers or neither or one? Thanks, Tyler
__________________
swampster123 is offline   Reply With Quote
Old Sponsored Links Remove Advertisement
Advertisement
Old 10-26-2012, 09:12 PM #2
Tabris17
Will B/S/T Souls
 
Tabris17's Avatar
 
Join Date: Jan 2006
Location: Connecticut
Annual Supporting Member
Tabris17 is a Moderator
Tabris17 is BST Legit
Tabris17 supports our troops
Tabris17 is one of the top 250 posters on PbNation
Tabris17 is Boss
Tabris17 is attending Decay of Nations VII
Page 1, right side half way down to the bottom has everything you need.
http://www.paintballsolutions.com/pd..._Manual_LR.pdf

Those washers are for fine tuning your pressures. They're included in the count to make 12 but it's 10 curved shims and 2 adjustment shims which are flat washers. Same you'll find in your reactor reg with the HP, 10 curved and 2 flat.
If you need further help and the ultimate sticky doesn't help then contact paintball solutions which is tech support for KEE/Empire.
__________________
Owner of the Silent Hill Cyborg... the most evil marker in paintball.
KGB MOB

"Only the foolish believe suffering is just wages for being different. Only the savage regard the endurance of pain as the measure of worth. Only the insane equate pain with success."

PBR Feedback +26/-0 PBN Feedback +16/-0 IOG Feedback +10/-0
Tabris17 is offline   Reply With Quote
Old 11-14-2012, 06:50 AM #3
Oldandsneaky
Still My Pump Badge
 
Oldandsneaky's Avatar
 
Join Date: Aug 2012
Location: Port Orchard, WA
Annual Supporting Member
Thanks for the info. I had to change a bonnet and a belleville washer fell out of the regulator. This helped me re-assemble the stack correctly.
Oldandsneaky is offline   Reply With Quote
Reply


Thread Tools

Posting Rules
Forum Jump